Cyclone Analogic Bass Bot Bedienungsanleitung PDF herunterladen (Seite 11)

The battery almost clipped into the holder.

Red marks the positive contacts, which hook over the edge of the main body of

the battery. On the right, but not visible are two small plastic hooks under which

the right edge of the battery clips once it is pushed into place. To remove an older

battery, use a fine screwdriver at the right edge of the battery to lever the battery

to the left and upwards, out of the grip of those plastic clips.

The battery properly clipped in.

The battery and holder, within a tube of white plastic (which happens to be

heatshrink, but has not been shrunk), ready for the machine to be re-assembled.

5 - Reassembly is the reverse of the disassembly procedure, but please take care that

no wires are caught against the pillars of the bottom part of the case. Please use

an ordinary screwdriver, not an electric screwdriver, to tighten the screws. Do not

do them up very tight, since this tends to strip what little plastic may be present in

the support pillars.

6 - Make a note to yourself, such as inside the lid of the battery compartment cover,

about when you installed the battery.

1 2 ... 6 7 8 9 10 11 12 13 14

Keine Kommentare

Cyclone Analogic Bass Bot Bedienungsanleitung Seite 11